SRW SF-8 Spray Foam Adhesive, 24 oz Can
One Can, Twenty Tubes of Work
A canister foam adhesive that changes the pace of wall-cap and coping work: one 24 oz can replaces more than 20 traditional adhesive tubes at a 3/8 inch bead, applies up to 50 percent faster, and is tack-free in about 8 minutes. Rated to 250 degrees, happy on damp surfaces, and it bonds nearly everything on a hardscape site. Requires the SF-8 dispenser gun.
|
Ships Same Day From our NJ warehouse |
24 oz can One size |
1 can replaces 20+ traditi… Key spec |
Real Humans (856) 418-4895 |
Why Contractors Ask for SF-8 Spray Foam Adhesive by Name
Cheap adhesive fails in the seasons, not in the showroom: bonds that let go after a winter, beads that would not stick to damp block, caps that walk off a wall.
- 1 can replaces 20+ traditional adhesive tubes (3/8 inch bead).
- Up to 50% faster application, 8 minute tack-free.
- Fastest set-up in the SRW adhesive line.
- Rated to 250F, bonds dry or damp surfaces.
Coverage: How Far One Can Goes
Per SRW's technical data sheet:
- One 24 oz can: replaces about 20 tubes of traditional 10 oz adhesive at a 3/8 inch bead
Tack-free in 8 minutes, fully cured in 24 hours.
Where SF-8 Spray Foam Adhesive Works
SF-8 Spray Foam Adhesive is recommended by SRW Products for the materials below:
- Retaining wall caps and block
- Pavers, steps and natural stone
- General construction bonding
Where SF-8 Spray Foam Adhesive Should NOT Be Used (Straight From the Manufacturer)
We would rather tell you this before you buy than argue about it after. Per SRW's technical data sheet, do not puncture or incinerate the can, and do not store above 120F. Protect cans from direct sunlight.
Not sure if your project qualifies? Call or text us at (856) 418-4895 before you order. We will give you a straight answer, even if the answer is that this is not the right product for your job.
Installation at a Glance
The full step by step guide is in the official TDS below. Here is the shape of the job:
- Surfaces. should be clean and sound; check the label for damp-surface allowances.
- Cut. the nozzle to bead size and apply per the label pattern.
- Join. the pieces within the working time and support as needed while it sets.
- Allow. full cure per the label before loading.
Check the label's application temperature range before starting, and always test adhesion on your specific materials first.
Quick Answers
How much working time do I have?
It varies by product; check the label before the first bead. Fast products reward having everything dry-fit first.
Cold weather?
Each adhesive lists its application range. If you are building in the shoulder seasons, our Superior Strength line extrudes down to 10F.
How long until full strength?
Set time gets you hands-off; full cure per the label is when it takes real load.
What temperatures can I work in?
SRW rates application from 32F to 95F, with materials bonded in about 8 minutes and full cure in 24 hours.
Official SRW Products Documentation
Download the SF-8 Spray Foam Adhesive TDS (PDF) →
Documents are published by SRW Products. For the most current versions, visit srwproducts.com.
Order before our daily cutoff and your SF-8 Spray Foam Adhesive ships today from New Jersey.
Questions about your project? Call or text (856) 418-4895 and you will get a real person who works with these adhesives every day.
Not sure how many 50 LB bags of polymeric sand your paver project will need? Try our Polymeric Sand Calculator