Techniseal Stripper for Concrete and Masonry, 5 Gallon

Why Contractors Ask for Stripper for Concrete and Masonry by Name

Stripping is the worst job in hardscape maintenance, and most of what makes it awful is scraping. A stripper that rinses off changes the labor on the job completely.

• It rinses with water and does not need scraping. That is the headline, and on a large floor or facade it is the difference between a day and three.
• It works on vertical surfaces. Floors, walls, and facades are all rated, which opens up building maintenance work rather than only paving.
• Broad masonry approval. Concrete, brick, and roughcast are all named by Techniseal.
• Known coverage. 500 to 625 sq ft per 5 gallon container, varying with surface condition, so a large job can be estimated properly.
• It comes in a working size. Stripping is a volume job, and a 5 gallon container is sized for the reality of it.

Stripper for Concrete and Masonry Specifications

Techniseal gives 500 to 625 sq ft per 5 gallon container and notes consumption varies with surface condition. A rough or heavily coated surface lands at the low end of that range.

Where Stripper for Concrete and Masonry Works

This is a volume stripping product for buildings and large paved areas.

• Removing alkyd sealers from concrete floors
• Brick and masonry walls and facades
• Roughcast and rendered surfaces
• Commercial and industrial floor stripping
• Large area paving where scraping would be impractical
• Building maintenance and restoration work

How to Use Stripper for Concrete and Masonry

Follow the official Techniseal instructions and safety data sheet, linked below. This is the shape of the job:

1. Identify the existing sealer. If it is acrylic, stop and use a different product.
2. Confirm the work area can be properly ventilated, and plan how you will block access to treated surfaces.
3. Test in a small discrete area to confirm the coating responds and to time the dwell.
4. Apply per the technical data sheet across the working section.
5. Keep people and pets off the treated area throughout, and post or barrier it.
6. Rinse thoroughly with water. No scraping should be needed.
7. Let the surface dry completely before applying anything new.

The access control instruction is not boilerplate. A surface covered in active stripper is both slippery and caustic, and on a commercial job that needs barriers and signage, not just good intentions.