Gator Natural Stone Color Enhancer: How to Apply and Coverage

Alliance Gator Seal Signature Series Natural Stone Color Enhancer, 1 gallon

Polymeric Sand Store Hardscape Experts |

Gator Seal Signature Series Natural Stone Color Enhancer is Alliance's zero gloss sealer for natural stone. It is a water based sealer built on silicone based polymers that darkens and enriches the stone to roughly the depth it has when wet, with no shine and no film on top. Alliance rates it for granite, travertine, limestone, sandstone, bluestone, flagstone and more, horizontal or vertical, inside or out.

Because the darkening is permanent without stripping and varies from stone to stone, the test patch matters more here than with most sealers. This guide covers what the product is, where Alliance says to use it and not use it, the application steps in Alliance's order, and coverage by stone type, using figures from the Alliance Gator Signature Series Natural Stone technical data sheet and our product page.

Quick answer

  • A water based, silicone based, non film forming sealer that darkens natural stone with zero gloss. Sold in 1 gallon and 5 gallon sizes.
  • Coverage depends on the stone: 200 to 400 sq ft per gallon on sandstone and bluestone, up to 500 to 700 on travertine.
  • Apply at 50°F to 80°F, one coat, wipe the excess after 5 to 10 minutes, repeat after 30 minutes if needed.
  • Foot traffic after 8 hours, vehicles after 72 hours, rain safe at 24 hours. Unsealed surfaces only, and it is not anti slip.

What Gator Signature Natural Stone Color Enhancer is

Alliance Gator Seal Signature Series Natural Stone Color Enhancer sits in the same Signature Series as the Natural Look sealer. The difference between the two is the color change:

Feature Signature Natural Look Signature Natural Stone Color Enhancer
Look Natural look, slight color enhancement Darkens the stone to a wet look depth, zero gloss
Film Non film forming Non film forming; nothing sits on the surface to peel or blush
Base Water based Water based, silicone based polymers
Use it when You want protection with no real color change You want richer, darker stone without shine

Alliance says it guards against deicing salt corrosion, UV, and motor oil and grease staining, and it names salt water pool patios specifically as an intended use. If you want protection with no color change at all, use the Signature Series Natural Look instead.

Gator Signature Natural Stone Color Enhancer specifications

Specification Per Alliance
Finish Zero gloss, darkens color, wet look effect
Base Water based, silicone based polymers, non film former
Coats One coat, may repeat after 30 minutes if needed
Wipe excess After 5 to 10 minutes
Application temperature 50°F to 80°F (10°C to 27°C)
Foot traffic 8 hours
Vehicle traffic 72 hours
Rain safe 24 hours
Sizes 1 gallon and 5 gallons

Where to use it (and where not to)

Alliance rates it for these stone types, interior and exterior, horizontal and vertical:

  • Granite, slate and marble
  • Limestone and travertine
  • Sandstone, flagstone and bluestone
  • Flamed and textured stone
  • Salt water pool patios

It also works on walls and cladding as well as patios. The limits, straight from the manufacturer:

  • Unsealed surfaces only. It cannot be used as a resealer.
  • Do not dilute it. It is not resistant to acids or caustic chemicals.
  • Not for food handling surfaces, glazed tile or any non porous surface. No kitchen counters.
  • Not anti slip. Take precautions around pools and showers.
  • Do not pressure wash the sealed surface.
  • Wait 60 days after the stone is installed.

For more on stone and finishes, see wet look vs natural look paver sealer.

How to use Gator Signature Natural Stone Color Enhancer

This is Alliance's sequence. The full step by step is on the data sheet.

  1. Test roughly 4 sq ft in a hidden area. Alliance calls this essential here, because the darkening effect varies by stone.
  2. Remove stains with Gator Clean products, or Gator Sealer Stripper for unknown coatings.
  3. Replace contaminated joint material with Gator polymeric sand, and wait 48 hours above 50°F with no rain. See how to replace polymeric sand.
  4. Clean the whole surface with Gator Efflorescence Cleaner, which Alliance lists as the required preseal clean, then wait 48 hours to dry.
  5. Apply one coat in 60 sq ft sections by sprayer, roller, squeegee, sponge or rag.
  6. Wipe the excess after 5 to 10 minutes with clean, dry, lint free cotton cloths. Repeat after 30 minutes if the stone still wants more.

Then keep foot traffic off for 8 hours and vehicles off for 72 hours; it is rain safe at 24 hours. Our guides on cleaning before sealing, the full sealing process and how long to wait after sealing fill in the general steps.

How much darker will my stone go?

Enough that you should always test first. The effect is roughly what the stone looks like when wet, and it is permanent without stripping. Porous stone such as sandstone and limestone darkens most and uses the most product. Dense stone such as granite and travertine darkens less and goes much further per gallon. Flamed and textured finishes take it well and gain a lot of depth.

How much Gator Signature Natural Stone Color Enhancer you need

Coverage depends heavily on how porous your stone is; sandstone drinks more than twice what travertine does. Alliance's figures per gallon:

Stone Coverage per gallon
Travertine 500 to 700 sq ft
Granite 400 to 600 sq ft
Limestone 300 to 500 sq ft
Sandstone 200 to 400 sq ft
Bluestone 200 to 400 sq ft

For stone types not in this table, check the manufacturer data sheet in our TDS and SDS library. Measure your area and use our paver sealer coverage calculator with the figure for your stone. To try the color change before buying a full gallon, we carry a Signature Series Natural Stone Color Enhancer sample for your hidden area test. Or call (856) 418-4895 with your stone type and square footage.

Safety and storage

  • It is not anti slip. Take precautions around pools and showers.
  • Do not dilute it. Alliance notes it is not resistant to acids or caustic chemicals.
  • Keep it off food handling surfaces.

For storage and handling details, check the data sheet in our TDS and SDS library and follow the label directions.

Watch the manufacturer's video

Frequently asked questions

Does the Natural Stone Color Enhancer add any shine?

No. It is a zero gloss product. It darkens and enriches the color without any surface sheen.

Can I use it on a wall or vertical stone?

Yes. Alliance rates it for horizontal and vertical surfaces, interior and exterior, including walls and cladding.

Is it suitable around a salt water pool?

Alliance names salt water pool patios as an intended application. It is not anti slip, so take the usual precautions.

How long before I can drive on it?

72 hours for vehicles and 8 hours for foot traffic. It is rain safe at 24 hours.

Can I pressure wash it afterwards?

No. Alliance advises against pressure washing the sealed surface.

Ready to bring out your stone? Order Gator Signature Natural Stone Color Enhancer, which ships same day from our New Jersey warehouse, or browse the full Alliance Gator range and our paver and stone sealers. Call us 24/7 at (856) 418-4895 with your stone type and square footage.

Leave a comment